NORAM 65ET GRADER
6-1
Lubrication and Maintenance - CAT Tier 4 Final
6
General Information
SECTION 6: LUBRICATION AND MAINTENANCE -
CAT TIER 4 FINAL
Proper machine operation depends upon a properly maintained machine. This section provides a list
of items to be checked, inspected or changed periodically.
When performing maintenance, always park motor grader on level ground with the moldboard on the
ground and implements pinned in place or lowered to the ground.
Dispose of all used fluids and filters according to federal, state and local regulations.
GENERAL INFORMATION
Master Switch - Battery Ground Disconnect
Inside the right side engine access door is a Master
Switch
(1). When in the OFF (vertical) position the
ground circuit to batteries is opened. Turn switch OFF
and remove key when the machine will be parked for long
time periods or while servicing. To operate machine, turn
Master Switch ON.
NOTICE: DO NOT turn master switch OFF while lamp (2)
is illuminated. Lamp remains ON approximately 2 minutes
after engine is shut down.
NOTICE: Disconnecting battery too soon will prevent
purging of the DEF lines after engine is shut down. Damage to the DEF system and emission control
system can occur.
Wait to Disconnect Lamp
When lamp is illuminated DO NOT place the master switch in the OFF position.
Never grease, service or adjust machine with engine running, except as specified
in this manual or the service and repair manual.
Failure to turn master switch off before servicing may result in electrical shock or
damage to machine components.
To Next Page
Loading...