NorAM 65 E T4 FINAL - Every 2000 Hours or 1 Year; Hydraulic Oil -Change

NORAM 65ET GRADER
4-37
Lubrication and Maintenance - Grader Components
4
Every 2000 Hours or 1 Year
EVERY 2000 HOURS OR 1 YEAR
Hydraulic Oil -Change
NOTE: Change hydraulic oil filter and strainers whenever changing hydraulic oil.
Change hydraulic oil when oil is cold.
1. Remove hydraulic tank fill cap.
2. Open access door.
3. Remove plug
(1) and open valve (2) to drain oil. Use a
suitable container to catch drain oil. Dispose of waste
oil according to federal, state and local regulations.
4. When drained, close valve and install plug. Fill with
62.5 L (16.5 gal) of clean oil.
5. Replace fill cap.
6. Start engine and operate implement controls to ensure all lines are filled.
7. Stop engine and check oil level on sight gauge. Add oil to bring level to the middle of the gauge.
Fluid in the hydraulic cylinders and lines is under pressure. Lower implements to
ground, shut off engine and move control levers several times to relieve
pressure.
1
2