NORAM 65ET GRADER
4-38
Every 2000 Hours or 1 Year
1
4
Lubrication and Maintenance - Grader Components
Rear Axle Housing Oil - Change
Change oil in rear axle housing with oil temperature at or near normal operating temperature.
1. Remove level check plug
(1) at rear of center housing.
2. Remove drain plug
(2) and allow oil to drain. Catch
drain oil in suitable container.
NOTE: Allow adequate time for oil to drain from axle
sections into center housing.
3. After oil is drained, clean area around drain and
install drain plug.
4. Fill axle at center housing until level is even with
bottom of check plug.
NOTE: Allow adequate time for oil to fill axle sections.
To Next Page
Loading...