NorAM 65 E T4 FINAL - Service Intervals; Preventing Contamination; Accessing Lubrication and Check Points

NORAM 65ET GRADER
6-2
General Information
1
6
Lubrication and Maintenance - CAT Tier 4 Final
Service Intervals
The recommended intervals listed on the chart should be adjusted when operating in severe
conditions. Time intervals should be checked when the machine reaches either the number of hours
or the time allotment, whichever comes first. As an example, if the motor grader has accumulated
1200 hours and a year has passed since hydraulic oil was replaced, change the hydraulic oil now
rather than waiting until 2000 hours have passed.
Preventing Contamination
To prevent contamination when changing oils, filters, etc., always clean the area around the filler
caps, level plugs, drain plugs, dipsticks and filters prior to removal. To prevent dirt entry during
greasing, wipe dirt from the grease fittings before attaching grease gun. All grease fittings are
equipped with caps which must be removed before attaching grease gun. Reinstall cap after wiping
off excess grease to prevent dirt entry.
Accessing Lubrication and Check Points
In order to access many of the lubrication and check points during service and maintenance
procedures, shielding will need to be removed and the hood opened or removed.
After service and maintenance work is complete, shielding must be reinstalled
before operating the machine.