NORAM 65ET GRADER
6-11
Lubrication and Maintenance - CAT Tier 4 Final
6
Every 500 Hours or 1 Year
1. Remove the cover (2).
2. Carefully remove the primary element
(3) taking care
not to disturb the inner element or knock any dirt off
the outer element.
3. Cover the air inlet with tape to keep dirt out.
4. Clean the inside of the air cleaner cover and body with
a clean, dry cloth.
5. Remove tape from the air inlet.
6. Install cleaned or new element in filter assembly by
firmly pressing into place.
7. Install air cleaner cover.
8. Reset air cleaner service indicator, 4.
NOTE: Replace the secondary element (3) for every three cleanings of the primary air cleaner
element.
Refer to “CAT C3.4B Industrial Engine Operation and Maintenance Manual” for complete
instructions.
To Next Page
Loading...