NORAM 65ET GRADER
6-15
Lubrication and Maintenance - CAT Tier 4 Final
6
Every 500 Hours or 1 Year
Fuel Filters - Change
Refer to Engine Operation and Maintenance Manual supplied with machine for instructions.
NOTICE: Ensure the engine is stopped before any servicing or repair is performed.
1. Drain the fuel from the primary filter
(1) through the
filter drain, located on bottom of filter, into a suitable
container and dispose of properly.
2. Remove the filter and dispose of properly.
3. Remove the secondary fuel filter
(2) and dispose of
properly.
NOTE: Over-tightening of the filter will distort
threads, filter element seal or filter.
Priming the Fuel System
It will be necessary to manually prime the fuel system (1)
if one of the following conditions exist.
• The fuel injection pump is replaced.
• The fuel lines are replaced.
• Start up after an extended period of time.
Fuel leaked or spilled onto hot surfaces or electrical components can cause a
fire. To help prevent possible injury, turn the ignition switch off when changing
fuel filters or water separator elements. Clean up fuel spills immediately.
To Next Page
Loading...