NORAM 65ET GRADER
2-13
General Information
2
Component Identification and Locations
Operator’s Door (Cab-Equipped Models)
Lockable doors (1) are provided on both sides of the cab.
Rotate the key toward the door to lock or rotate the key
away from the door to unlock.
To open a door from the outside, push in the button and
pull the door open. To open the door from the inside, push
the handle forward and push the door open.
The door can be opened fully and secured to the back of
the cab during operation. To release door, pull latch
handle
(2) on the outside of the cab upward.
NOTE: The same key is used in the ignition, door,
and engine access panels.
Windows (Cab-Equipped Models)
The front and rear windows open for ventilation. Open
the rear window by releasing the latch
(1) on the left side
of the cab and slide the window to the right.
The front window is hinged at the top. Two latches
(1) at
the bottom can be released and the front window will
pivot forward. A detent in each latch holds the window
open.
To Next Page
Loading...