1
NORAM 65ET GRADER
3-20
Operation
3
Moldboard and Implement Operation
Inching Control
If brake pedal is depressed and the Inching Control,
displayed on the screen, is deactivated, the transmission
will disconnect and will not transfer power to the wheels.
The transmission will engage when the brake pedals are
released.
If the Inching Control is activated, the transmission will
continue to drive the machine. The machine will slow and
stop as foot pressure is increased on the brake pedal.
Inching control is always reset to the deactivated mode
when the key switch is turned off.
Changing Direction
To change direction of travel:
1. Reduce engine speed below 3/4 throttle.
2. Move transmission control lever all the way rearward to select reverse and all the way forward to
select forward. The machine will automatically down-shift in increments and shift into first gear
reverse or first gear forward.
NOTE: It is not necessary to stop machine travel before changing direction. The transmission
will modulate clutch engagement as needed.
To Next Page
Loading...