NORAM 65ET GRADER
4-6
General Information
1
4
Lubrication and Maintenance - Grader Components
Service Intervals
The recommended intervals should be adjusted when operating in severe conditions. Time intervals
should be checked when the machine reaches either the number of hours or the time allotment,
whichever comes first. As an example, if the motor grader has accumulated 1200 hours and a year
has passed since hydraulic oil was replaced, change the hydraulic oil now rather than waiting until
2000 hours have passed.
Preventing Contamination
To prevent contamination when changing oils, filters, etc., always clean the area around the filler
caps, level plugs, drain plugs, dipsticks and filters prior to removal.
To prevent dirt entry during greasing, wipe dirt from the grease fittings before attaching grease gun.
If any grease fittings are missing, replace them immediately.
To Next Page
Loading...