nord NORDAC SK 200E - 3 Sk 200 E Displays and Control

3 Displays and Control
BU 0200 GB Subject to technical alterations 41
3 SK 200E displays and control
As supplied, without additional options, the diagnostic LEDs are externally visible. These signal the actual
device status. 2 potentiometers and 8 DIP switches are provided in order to set the most important
parameters. In this minimal configuration no other adapted parameters are stored in the plug-in EEPROM.
The only exception is the data concerning operating hours, faults and fault circumstances. This data can be
stored in the EEPROM.


















SK200Emountedonmotor,topview SK200Enotfitted,viewfrominside
RJ12
LEDs
Potentiometers
Plug-in EEPROM

8x DIP switches

All parameters can be conveniently accessed for reading or setting with the aid of an optional SimpleBox or
ParameterBox (Section 3.2). The changed parameter data is stored in a non-volatile EEPROM memory.
This provides the possibility of transferring data from one FI to another by plugging in the EEPROM.
In addition, up to 5 complete frequency inverter data sets can be stored and accessed in the ParameterBox.
Connection between the SimpleBox or ParameterBox is by means of an RJ12-RJ12 cable.