Need help?Do you have a question about the Nordic nRF52833 DK and is the answer not in the manual?
General| Microcontroller | nRF52833 |
|---|---|
| CPU | ARM Cortex-M4 |
| Clock Speed | 64 MHz |
| Flash Memory | 512 kB |
| RAM | 128 kB |
| Bluetooth | Bluetooth 5.1 |
| NFC | Yes |
| Operating Voltage | 1.7 V to 3.6 V |
| Temperature Range | -40 °C to +85 °C |
| Debug Interface | SWD |
| ADC | 12-bit ADC |
| Connectors | USB |
| GPIO | 48 |
| Development Kit Features | Button, LEDs, User-programmable buttons and LEDs, Arduino Uno Revision 3 compatibility |
Details on the physical components included with the development kit.
Lists additional documents for further reference.
Functionality of the boot/reset button on the interface MCU.
UART interface provided via a virtual COM port for communication.
Mass Storage Device functionality for drag-and-drop programming.
Visual representation of the DK's layout and component connections.
Details on how the DK is powered from various sources.
Explains different operational states and signal switching mechanisms.
Details on external connectors and pin mappings for GPIO access.
Information on user interface elements and the 32.768 kHz crystal.
How to debug the SoC and program external boards.
NFC functionality and configuration options via solder bridges.
Steps to configure the DK for accurate current measurements.
Using an oscilloscope to capture and analyze current profiles.
Using an ampere-meter to monitor average current consumption.
To Next Page
