Installation
A1-42
E 2000 Nordson Corporation
All rights reserved
41-3000V
Issued 5/00
A3EN-04-[3V-A-AAXP]-12
3. Determine which SYSTEM SETTINGS feature to customize. Refer to
Table A 1-12 for a list of defaults and options for customizing each
feature.
WARNING: Risk of fire. The default for the overtemperature
setpoint is 218 _C (425 _F). If the Material Safety Data Sheet
(MSDS) for your adhesive gives a flash point that is below
218 _C (425 _F), be sure to reset the overtemperature setting to
at least 42 _C(75_F) below the flash point.
4. See Figure A 1-31. Press the Up key (1) below the Selector
display (2) until the number of the feature you want appears on the
display. As the feature number changes, the Multipurpose display (3)
changes to show the setting of each feature selected.
5. Press the Up or Down keys (4) below the Multipurpose display to
change the setting. The display flashes.
6. Press the Enter (5) key to save the new setting. The display stops
flashing.
4130012
2
3
4 5
1
Fig. A 1 -31 Changing the Setting of a Selected Feature
1. Up key
2. Selector display
3. Multipurpose display
4. Up and Down keys
5. Enter k ey
7. Record your setting in the forms provided at the end of this section.
Refer to Records of System Settings.
8. Repeat steps 4 through 7 for each feature you wish to change.
9. To exit the System Setup area, press the MONITOR/SCAN key.
og
a
gSYST
TT
GS Co
o
(contd.)
To Next Page
Loading...
Need help?
General
