Nordson 3100V Series User Manual

Installation
A1-41
E 2000 Nordson Corporation
All rights reserved
41-3000V
Issued 5/00
A3EN-04-[3V-A-AAXP]-12
If your unit has an optional I/O board, you can program additional
features. Refer to Series 3000V Input/Output Board in the Options
section for information on programming these additional features.
Use this procedure to program the SYSTEM SETTINGS features shown
in Table A 1-11.
1. If you have not already done so, turn power on to the unit by pressing
the POWER switch.
2. See Figure A 1-30. Press the Move Up (1) and Move Down (2) keys
until the SYSTEM SETTINGS light turns on. When you select
SYSTEM SETTINGS, the following occur:
S The values in the Displays area change.
S The number in the Selector display changes to a feature number.
S The Multipurpose display changes to the current value for the
feature selected.
4103988
1
2
Fig. A 1-30 Selecting SYSTEM SETTINGS Features
1. Move Up key 2. Move Down key
NOTE: If you have enabled the password feature, you must
change the number in the Multipurpose display (500) to the
password (321) and press the Enter key before the system will
allow you to change any SYSTEM SETTINGS features.
P
r
og
r
a
m
m
i
n
gO
p
t
i
o
n
a
l
F
ea
t
u
r
e
s
P
r
og
r
a
m
m
i
n
g SYST
E
M
S
E
TT
I
N
GS Co
n
t
r
o
l
s

Nordson 3100V Series Specifications

General

Brand	Nordson
Model	3100V Series
Category	Melting Machines
Language	English