Installation
A1-53
E 2000 Nordson Corporation
All rights reserved
41-3000V
Issued 5/00
A3EN-04-[3V-A-AAXP]-12
4. See Figure A 1-35. Check that the day code (1) is correct.
Correct?
Action:
Yes Press the Enter key (4) to save the setting.
No Press the Up key (6) below the Selector display until
the correct code appears on the display; then press
the Enter key to save the setting.
5. When you press the Enter key, the Selector display stops flashing
and the hour (2) shown in the Multipurpose display begins flashing.
Check that the hour shown in the Multipurpose display is correct.
NOTE: Clock hours must be set to come on between 01:00 and
24:00 hours. If the clock is set from 00:01 to 00:59, it will not operate.
Correct?
Action:
Yes Press the Enter key to save the setting.
No Press the Up or Down key below the Multipurpose
display until the correct hour appears on the display;
then press the Enter key to save the setting.
6. When you press the Enter key, the hour shown in the Multipurpose
display stops flashing and the minutes (3) shown begin flashing.
Check that the minutes shown in the Multipurpose display are correct.
Correct?
Action:
Yes Press the Enter key to save the setting.
No Press the Up or Down key below the Multipurpose
display until the correct minutes appear on the display;
then press the Enter key to save the setting.
NOTE: Once the clock is set, all displays stop flashing.
To Next Page
Loading...
Need help?
General
