Tank, hose, and applicator keys
Operation
4-19
Part 1073401_07
E 2021 Nordson Corporation
To adjust the setpoint temperature using the global‐by‐component
method
1. Press and hold the Hose or Applicator key for three seconds.
The left display indicates the number of the first sequential hose or
applicator. The right display indicates the current setpoint temperature of
the hose or the applicator.
2. Scroll the left display to 0.
The right display indicates all dashes (‐‐‐‐).
3. Press a right‐display scroll key.
The right display flashes.
4. Use the right‐display scroll keys to enter the setpoint temperature
recommended by the manufacturer of the hot melt. Refer to the technical
data sheet provided by the manufacturer of the hot melt to determine the
optimal setpoint temperature.
NOTE: If the right‐display scroll keys have no affect on the right display,
the melter is password protected. You must enter a valid password
before you can change setpoint temperatures. Refer to Entering the
Melter Password later in this section.
5. Press the left‐display scroll key.
The hoses or the applicators begin to heat or cool to their new
setpoint temperature.
To Next Page
Loading...
Need help?
General
