Safety
A 1-5
E 2015 Nordson Corporation
All rights reserved
321222_06
Issued 04/2015
A1EN−02−[XX−SAFE]−1
S In a humid environment, only equipment featuring a corresponding
class of protection may be operated.
S Do not operate the unit in an explosive environment.
S Keep parts of the body or clothing away from rotating parts. Do not
wear loose articles of clothing when operating or servicing units with
rotating parts. Take off wrist watches, rings, necklaces, or similar
pieces of jewelry and pin up or cover long hair before performing any
work on or with the unit.
S To carry out measurements on work pieces, switch off the unit and
wait until it comes to a standstill.
S Never point hand guns or applicator nozzles at yourself or other
persons.
WARNING: An operator or service technician working with the
unit should be aware of less-obvious dangers that often cannot
be completely minimized at production sites:
S Exposed surfaces of the unit which cannot be practically
safeguarded. They may be hot and take time to cool after the unit
has been operating.
S The possibility that electrical potentials may remain in the unit after
the unit was de-energized
S Hot melt material and vapors
S Hydraulically or pneumatically operated parts of the unit
S Parts winding something up or down which are not covered
If the unit malfunctions, switch it off immediately.
S Turn the circuit breaker or main power switch OFF.
S Have the unit repaired by qualified personnel only.
Less-Obvious Dangers
Action in the Event of Unit
Malfunction
To Next Page
Loading...
