Safety
A 1-7
E 2015 Nordson Corporation
All rights reserved
321222_06
Issued 04/2015
A1EN- 02- [XX- SAFE]- 1
S Follow the specific instructions provided in this manual to relieve the
system pressure in the entire unit.
S Secure pneumatically- or hydraulically-operated equipment against
uncontrolled movement.
S Only use parts which do not compromise the safety of the unit. Only
use genuine Nordson parts.
S Always use tools with insulated handles when removing or installing
components.
NOTE: Always refer to the material manufacturer's Safety Data Sheet
(SDS) or material information sheet before working with any material.
WARNING: Never clean any aluminum part or flush any system
using halogenated hydrocarbon fluids. Examples of common
halogenated hydrocarbons are: dichloromethylene,
1,1,1-trichloroethylene, and perchloroethylene. Halogenated
hydrocarbons may react violently with aluminum parts.
WARNING: Fire, open flame, and smoking are prohibited when
cleaning fluids are used. Observe all explosion prevention
regulations. Cleaning fluids may only be heated using
temperature-controlled and explosion-protected heaters.
S Never use an open flame to clean the unit or components of the unit.
S Use only cleaning fluids designed or intended to be used with the hot
melt material being used in the unit. Never use paint fluids under any
circumstances.
S Note the flash point of the cleaning fluid used. Only use a controlled
heating method to heat fluids.
S Ensure sufficient room ventilation to draw off generated vapors. Avoid
prolonged breathing of vapors.
8. Cleaning
To Next Page
Loading...
