Safety
A 1-6
E 2015 Nordson Corporation
All rights reserved
321222_06
Issued 04/2015
A1EN−02−[XX−SAFE]−1
Contact with hot melt materials or hot areas of the unit may produce a
severe skin burn.
WARNING: Hot! Risk of burns. Wear heat-protective clothing,
safety goggles, and/or heat-protective gloves depending on the
symbols shown.
S Be extremely careful when using hot melt material. Even solidified
material may still be very hot.
S Always wear protective clothing which safely covers all exposed parts
of the body.
In case of burns:
S Immediately cool affected skin areas using cold, clean water.
S Do not forcefully remove hot melt material from the skin.
S Immediately seek medical attention.
Allow only qualified personnel to perform the procedures described in this
document. When performing such tasks, wear protective clothing, and
equipment.
WARNING: Even when the circuit breaker or main power
switch is OFF, the unit is still electrically energized. Complete
the following steps prior to maintenance or repair:
S Disconnect, lock out, and tag external power supply.
S To ensure the external power supply is disconnected, attempt to
operate the unit. If the unit does not energize, proceed with
maintenance or repair work.
S If the unit energizes, repeat the disconnect, lock out, and tag
procedure. Re-test the unit.
Danger of Burns
7. Maintenance/Repair
To Next Page
Loading...
