Nordson TCB User Manual

Installation, Operation and Maintenance Manual
4
TABLEOFCONTENTS
1. Introduction 6
2. Delivery and MOUNTING INSTRUCTIONS 8
2.1. Enclosure location 8
2.2. Pneumatic installation 8
3. Electrical installation 9
3.1. Main switch IP65 9
3.2. Motor connection 9
3.3. Supply voltage: terminals 1 and 2 10
3.4. RS-485 Bus: terminal 3–5 10
3.5. Motor protection: terminals 25, 28 10
3.6. Optional isolation amplifier for thermistor protection and/or bursting disc: terminals 6–9 11
3.7. Connections for Fan starters : terminals 14–17 (+ 12 & 13 for ECB 4 units) 11
3.8. Alarm relay: terminals 18–20 11
3.9. Remote start/stop push buttons: terminals 21–23 11
3.10. Input external on: terminal 24, 28 11
3.11. Outputs for remote control lamps: terminals 29–31 12
3.12. Optional analogue output: terminals 32–34 12
3.13. Valve outputs: terminals V1–V16 – Single module systems 12
3.14. Valve outputs: terminals V1–V16 – Multiple module systems 12
3.15. Rotary switches “Slave address” and “mode”. 12
3.16. Programmable inputs 13
3.17. Programmable outputs 13
4. Pre-Start-up checklist 15
5. Operation 15
5.1. Single Fan Afterfilter Systems 15
5.2. Multiple Fan Units e.g. ECB Units 15
5.3. Status LED’s 16
6. Using the menu system 17
6.1. Display mode 17
6.2. Setting mode 17
7. Parameter/Memory fields description 19
7.1. P00 Setting Pin code 19
7.2. P02 Delta P Min 19
7.3. P03 Delta P Max 19
7.4. P04 Delta P Max Alarm 19
7.5. P05 Low Pressure Alarm 19
7.6. P06 Off Line cleaning Cycles 20
7.7. P07 Star/Triangle switch over Time 20
7.8. P09 Cleaning Pulse interval 1 20
7.9. P12 Cleaning valve Pulse time 20
7.10. P15 display Language 20

Nordson TCB Specifications

General

Brand	Nordson
Model	TCB
Category	Control Unit
Language	English