Nordson Ultimus II - Features & Controls: Back Panel; Power and Communication Ports; Input;Output (I;O) Interface

Power Input Port
The power input port is located at the top left corner of the Ultimus. The Ultimus power pack automatically adjusts
for 100 to 240 VAC.
Use only the universal power pack provided with the Ultimus workstation. The unit is shipped with four power plugs
(one USA and three international plugs) and an 1800 mm (5.9 ft) length power cord.
• Connect the DC plug from the cord to the Ultimus power input port.
• Connect the power cord to your local power source.
Communication Port
The Ultimus communication port, located on the top row of ports, is for EFD use only.
Input / Output 8-Pin Interface Connector
Input / output features are used when the Ultimus is interfaced with external control circuits. The 8-pin connector is
located on the top row of ports. Refer to “Input / Output Connection” on page 24 for details.
• An End-of-Cycle signal, in the form of an electronic switch, closes upon completion of the dispense cycle.
Chassis connection
This symbol identies the
chassis connection terminal.
Used for grounding the chassis
to shunt leakage current and
/ or enhancing system EFD
protection.
Foot pedal /
nger switch
Power
input port
Exhaust Input air
Communication
port
Input / output
(I/O) port
Features & Controls: Back Panel
Ultimus I–II High Precision Fluid Dispensers
15www.nordsonefd.com info@nordsonefd.com 800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.