Norstar M7310 - Page 33

: ‘:..,
‘. :
. . ..a :;
:. . ..-.!
.!
: ,.
_;::
:.
:.:
. . . . /
:,
‘,
Administration / 29
Entering Administration:
1.
2.
3.
4.
Release all calls on your M7324 or M7310 telephone.
Indicators for calls on other telephones stay ON.
Enter the following code: ~~~~~~~~
If the display changes to 1 Password :
1 , enter
the Administration password. If the proper password is
entered, the display shows 11 Sys speed d i CI I 1
and three triangular indicators ) appear on the LCD
panel between the rows of buttons.
If no password is required, the 11 Sys speed d i o I 1
display and the indicators appear as soon as the
Administration code is entered.
Place the Overlay over the four buttons pointed to by the
indicators. You are now at the starting point for each of
the following procedures.
.
1. Press ~ The display shows\ Show entry: _
2. Enter the two-digit Speed Dial code you wish to program
OR
3.
4.
5.
Press I until the desired code (01-70) appears.
Press ICHANGE Any previous entry is erased.
Enter the digits of the new telephone number, including
all digits, such as an initial q -or an area code, that
-
must be dialed to call the number manually.
Press WI to store the number and move to the next
System Speed Dial code.
6. When you are finished, follow the Exit procedure below.
To scan the System Speed Dial entries:
Begin with 11 Sys speed d i Q I I on the display, then follow the
steps below.
1. Press ~ The display shows Show entry :-_ ]
2. Press I[ The display shows 1~0 1 :
If a telephone number has been previously entered, it
will appear after the colon.
3. Press II repeatedly to look at the System Speed
Dial codes (01-70).
To move backwards through the entries, press ~
repeatedly.
4. When you are finished, follow the Exit procedure on the
next page.
To enter a new telephone number for a code:
Begin with 1 1 Sys Speed d i CI I I on the display, then follow the
steps below.
System Coordinator Guide
2. -