30
/ Administration
To erase a System Speed Dial code:
Begin with
11
Sys
sped d
i CI II on the display, then follow the
steps below.
1. Press -1 The display shows1
Show entry: -
2. Enter the two-digit Speed Dial code you wish to erase
OR
*-
,.i
,:1
Press m until the desired code (01-70) appears.
.-
3. Press lm The programmed telephone number
disappears from the display.
4. Press m The Speed Dial code is programmed with
no telephone number and the display shows the next
Speed Dial code in the sequence.
5.
Follow the Exit procedure below.
System Speed Dial Exit procedure:
To move to other Administration tasks:
1. Press m twice. The display shows
Il.Sys Speed
Dial 1
2. Press m or ~ to move to another heading.
To Exit from Administration:
1. Press m
System Coordinator Guide
To Next Page
