Norstar M7310 - Page 40

36 / Administration
8.
9.
Continue entering other characters of the Name using
the dialpad and cursor control keys. Remember that
there is a seven-character limit on Name length. If you
press m or ~ before entering any characters, ,_
the telephone’s set number is stored in place of a name. 2
To enter the Name for another telephone, press ~ ’
to return to/ Show set: _
1 sub-heading
OR
Press MI to show the next telephone in the
numbering sequence.
When you are finished, follow the Exit procedure on the
next page.
IO.
To enter a new name or change the name of an outside line:
Begin with 1 2. Names 1 on the display, then follow the
steps below.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Press ~ The display shows Set names
Press )I The display shows L i nr names
Press m[ The display shows Show I i ne: _
Enter the two-digit number of the desired line
OR
Press m to show the lowest numbered line in the
system.
Press ~ A cursor appears beside the colon.
Enter the first character of the desired Name by pressing
the appropriate dialpad button one, two, three, or four
times.
Press q or )-->) to move the cursor to the next space.
Enter the second character from the dialpad.
Continue entering other characters of the Name using
the dialpad and cursor control keys. Remember that
there is a seven-character limit on Name length. If you
press m or ~ before entering any characters,
the line number is stored in place of a name.
10. To enter the Name for another line, press ~ to
return to the 1 Show I i ne: _ 1 sub-heading
OR
-: .
Press I/ to show the next line in your system.
11. When you are finished, follow the Exit procedure on the
next page.
..:
--;
-L
System Coordinator Guide