48 /Administration
To scan the available Restrictions:
Begin with
14.
Res tr i c t i ens [on the display, then follow the
steps below.
:.. :
: :
‘..,
‘:.C-
1.
2.
3.
4.
Press m The display shows/
Tab I e entr i es
1
Press JShowl again. The display shows the first
Restriction table entry.
Press m repeatedly to scroll forward through the
table entries, as far as #30 if you wish. While a table
entry is displayed, you can press ~ to scroll
backwards through the entries. At #30, pressinq (Next1
changes the display to
[APP I
i
ed to I i ryes ]
When you are finished, follow the Exit procedure at the
end of this section.
To change a Restriction or enter a new one:
Begin with (
4.
Restr i ct i ens 1 on the display, then follow the
steps below.
1. Press JShow\ The display shows)
Tub I E entr i es
I
2. Press -1 again. The display shows the first table
entry.
3. Press m repeatedly until the desired entry or blank
space is showing on the display.
4.
Press
m Any previous entry is erased.
5. Enter the desired digit sequence from the dialpad.
The maximum number of permitted digits or asterisks is
eight.
6. Press MI to store the entry and move to the next
Restriction.
7. When you are finished, follow the Exit procedure at the
end of this section.
To scan or change Restrictions that apply to a line:
Begin with
14.
Res tr i c t i ens Ion the display, then follow the
steps below.
1. Press ~ The display shows
Tab I e Entr i es
2. Press m The display shows Appl i
ed to I ines
3. Press ~ The display shows
Show I i ne: _
System Coordinator Guide
i. -
To Next Page
