52 /Administration
Explanation of Restrictions Overview
From the
14.
Restr i ct i at-15 1 heading, press ~ to
get to
the first sub-heading 1
Tab I E en tr i es
1 The other two sub-
headings are 1 Rpp I
i ed
to I
i
nesl and IApp I
i ed to sets 1
1
You can move from one sub-heading to another by pressing m ’
or I
4
Fromthe 1
Table entries
/sub-heading you can see the
actual entries (restricted digits) by pressing lShowl and then m I
repeatedly. Enter a string of digits or erase an existing entry by
pressing ~ when the desired entry number shows on the
display, then entering the new digits from the dialpad or pressing
pkiq
Programming under 1 App I i
ed
to I i nes 1 follows the same
format as programming under I App
I
i
ed
to sets I From either
sub-heading, press m then enter the desired line or set
number. As the last digit is pressed, the display shows the first
table entry along with a Y (Yes) or N (No) to indicate whether the
Restriction is applied. You can apply or remove any Restriction
showing on the display by pressing ~
All of the Restrictions applied to a line or a telephone can be copied
to others by returning to the appropriate sub-heading, pressing the
loopy display button, and following the prompts which appear on
the display.
System Coordinator Guide
To Next Page
