Feature Operations / 105
Default Dual Memory Buttons
The M7310 telephone has 12 dual memory buttons which can be
programmed for access to features or Autodial numbers. By using
the Shift button with the dual memory buttons, you can program up
to 24 features or Autodial numbers. These buttons are located
above the M7310 telephone’s display, as shown on the photograph
below.
The M7310 Telephone
Dual memory buttons (on the M7310 telephone only) are pre-
I
programmed as Inside Autodial numbers corresponding to the
various telephones in the Norstar svstem. The default arranaement
of the Inside Autodial buttons is shown below. The diagram shows
the defaults for a system with three-digit Intercom numbers.
Norstar systems can have two, three, or four-digit Intercom
numbers; the choice is controlled by your Installer or Service
Representative in the “Change DNs” section of Configuration
rogramming.
Default Dual Memory Buttons
system Coordinator Guide
To Next Page
Loading...
