.
104 / Feature Operations
Autodial
The Autodial feature allows anyone to program buttons on their
Norstar telephones for one-touch dialing of outside numbers,
Intercom numbers, or feature codes. Autodial telephone numbers
are described in the following pages. For details on programming
Autodial buttons with feature codes, refer to Feature Access.
Inside Autodial
For one-button access to frequently-dialed Intercom numbers within
the Norstar system, use the Inside Autodial feature. Be sure that
your co-workers know how to program Inside Autodial numbers, as
they will probably have to change them from time to time.
Inside Autodial buttons can be programmed to dial any Intercom
numbers within your Norstar system, with the exception of “0”,
which calls the Dial Zero Phone.
With the Central Answering Position, composed of an M7324
telephone and one or two CAP Modules, Inside ALtodial buttons.
function in the same way as the Busy Lamp Field on an M7310
telephone. The indicators on the LCD panel indicate whether or not
the telephone associated with a Autodial button is active on a call.
For further details, see the “Busy Lamp Field” and “Central
Answering Position” sections of this chapter.
-.
To program Inside Autodial numbers:
1.
2.
3.
4.
Press lFeaturem12 The display shows
IPress R key 1
The display shows
On the M7310 teleghone, remember to oress the shift
button to program into the top half of a &al memory
button.
Enter the Intercom code to be stored. The display
shows
Key programmed
Label the memory button.
To use Inside Autodial:
1. Press an Inside Autodial button to make a call to a
selected inside number. The system selects a free
inside line, then places the call.
OR
Press an Inside Autodial button while connected to
another call. The first call is held automatically and the
new call is started.
.
:. :
System Coordinator Guide
To Next Page
Loading...
