Maintenance Commands 7
BMC II BISYNC Quick Reference Guide
File Manipulations Commands
*GETIDXu:v s.f Creates a new index file with a start-
ing secondary version and a starting
primary sequence number.
* These commands are only valid for BMC II BISYNC software loads
that were released after 1990.
NEWCRFf Closes open call record file and
opens new file.
f - filetype:
T - toll
M - message
O - OMR1
P - OMR2
v - starting primary version #.
u - starting secondary version #.
s - first sequence # to be primary.
Command Name Explanation
AFTii Lists the directory entry for the active
file specified.
ii - file id # from LSTACT.
CLOSEii Closes open file.
ii - file id # from FSYS.
DELETE ffffff vvv Deletes a particular file version.
DELETE ffffff mmm:nnn Deletes a range of versions of a particu-
lar file.
Example:
>DELETE AMCRD 3:150
Deletes filename AMACRD versions 3
to 150.
DIR ffffff vvv Lists the directory entry of a specified
file and version.
DIR ffffff mmm:nnn Lists the directory entry of a specified
file and range of versions.
DMP ffffff vvv b cccc Outputs a specified number blocks from
a specified file for examination.
ffffff - filename.
vvv - file version #. 0 is the latest ver-
sion (0-255).
mmm - starting versions: 1-255
nnn - ending versions: 1-255
must be larger than m.
b - Specifies starting block range
(0 - 999,999).
cccc - Specific number of block to
dump (0 - 9,999).
DSPs.fl Displays a selected block from BMC II
disk by sequence number.
DSPr To continue to display a selected range
of blocks from BMC II disk.
Command Name Explanation
To Next Page
Loading...
