22 Guide to Index Corruption Recovery
297-6201-501 97Q3 Standard 02.01 July 1997
TOL FILE ESTABLISHED
GOOD TOLIDX FILE
7. Delete the TOLCRD files that were forced into TO DLET status. To
delete the TOLCRD files in versions 106 through 108, enter the follow-
ing command at the maintenance terminal:
>DELETE TOLCRD 106:108 (cr)
8. To display the closed TOLCRD files in the new index, enter the follow-
ing command at the maintenance terminal:
>FILET.Z (cr)
System response:
VS 109: 1389 BLKS, 1389 TO POLL, TOL SEQ :008740
VS 110: 304 BLKS, 304 TO POLL, TOL SEQ :010129
VS 111: 632 BLKS, 632 TO POLL, TOL SEQ :010433
VS 112: 1085 BLKS, 1085 TO POLL, TOL SEQ :011065
END OF TOLIDX FILE
If the index listing exceeds 26 files, it will be necessary to issue the
FILET.Z command to display the next group of 26 files, until the end of
the index file is reached.
TOLIDX OPEN ERROR:03
1. Examine available TOLCRD files in the directory using the following
command:
>DIR TOLCRD 1:255 (cr)
2. Note sequence number in the versions that are displayed in the system
response.
00 TOLCRD 60 78 95 349 0 1531 01006C00 00 0EE509
063402 000076
00 TOLCRD 60 79 95 349 0 1531 01000000 00 0EE509
063478 000076
00 TOLCRD 60 80 95 349 0 1531 01000000 00 0EE509
063554 001980
00 TOLCRD 60 81 95 263 0 1531 01521201 00 0EE508
000000 003451
00 TOLCRD 60 82 95 349 0 1531 01006C00 00 0EE507
003451 000036
00 TOLCRD 60 83 95 349 0 1531 01000000 00 0EE509
003487 000036
00 TOLCRD 60 84 95 349 0 1531 01000000 00 0EE509
003523 001389
07 FILES LISTED
In the example above, the two-digit boldface number is the TOLCRD
file version number. The six-digit boldface number is the starting
sequence number of the version.
3. Contact data center. Verify what sequence numbers have been com-
pletely processed and will not need to be repolled, as well as at what
sequence number the data center needs to start normal polling.
4. Determine which versions contain the sequence numbers obtained from
the data center in step 3.
5. Create an TOLIDX containing the TOLCRD versions the data center
needs to poll. The following command should be used for most
BISYNC protocol BMC systems. BISYNC BMC systems equipped
To Next Page
Loading...
