Nortel DMS-10 - Statistics Commands; System Clock Commands

12 Maintenance Commands
297-6201-501 97Q3 Standard 02.01 July 1997
Statistics Commands
System Clock Commands
SITER Reads (restores) the site data parameters from
the BMC disk and over writes the main mem-
ory (RAM).
SITEW Updates (Saves) the site data parameters from
memory to disk.
*********************************************************
DMS-10 ONLY
TERM1aa Enables the BMC’s SDI Port terminal assign-
ment while disabling the Local TTY Port.
aa - DMS-10 SDI terminal number (0-99)
TERM2 Enables the BMC’s Local TTY Port while
disabling the DMS-10 SDI Port.*
*********************************************************
* Remember to save any changes using the SITEW command.
Command Name Explanation
REPTtp Displays a compiled list out of a selected sta-
tistical file available on the BMC II disk.
t - type: (1-3)
1 - TOLL
2 - DISK ERRORS
3 - POLLING
p - period: (T - today or Y - yesterday).
STATC Clears today’s statistics file reports.
Command Name Explanation
STIMyymmddhhmmssd Changes the time on the BMC II clock.
yy - year: (00-99)
mm - month: (01-12)
dd - day: (01-31)
hh - hour: (00-23)
mm - minutes: (00-59)
ss - seconds: (00-59)
d - day: (1-7 1 - MON, 7 - SUN)
TIM Display time of active processor.
MONS (cr)
TIM
Display time of standby processor.
Note: After displaying the clock on the standby, type (CTRL)Z to get
out of the MON> overlay
Command Name Explanation