Maintenance Commands 11
BMC II BISYNC Quick Reference Guide
Note: After using any of these commands, type (CTRL)Z to get out of
the KYWD> overlay.
Note: The following commands must be used while in the LKEY>
overlay.
LKEY Enters the LKEY> overlay.
E Displays the Local password.
Cxxxxxx Changes the Local password.*
xxxxxx - six character password.
Note: After using any of these commands, type (CTRL)Z to get out of
the LKEY> overlay.
LPADE Examines the current one byte leading pad
character used in the BISYNC protocol dur-
ing call record polling.
LPADxx Changes the current one byte leading pad
character used in the BISYNC protocol dur-
ing call record polling. The leading pad char-
acter cannot start with an E.
xx - two-digit pad character (HEX).
*********************************************************
DMS-10 ONLY
PASS?L Displays DMS-10 password.
PASS?xxxx Changes the DMS-10 password.*
xxxx - 4 digit password.
*********************************************************
Note: The following commands must be used while in the PSWD>
overlay.
PSWD(cr) Enters the PSWD> overlay.
A nnnnnn p Adds a new password to the system.
uC n p Changes a currently assigned password or pri-
ority level.*
uD Deletes the selected user number password
(#=0-9)
u - user number
nnnnnn - 6 char alphanumeric password
p - priority 1-3 (1 - lowest, 3 - highest).
L Displays the user passwords and the associ-
ated priority level.
Note: After using any of these commands, type (CTRL)Z to get out of
the PSWD> overlay.
RMIDL Lists the assigned remote station identifica-
tion.
RMIDnC xxx Changes the remote station identification.*
n - remote station number
xxx - three character ID for remote station.
Command Name Explanation
To Next Page
Loading...
