Need help?Do you have a question about the Nortel DMS-10 Series and is the answer not in the manual?
General| Technology | Digital |
|---|---|
| Control | Stored Program Control (SPC) |
| Redundancy | Yes |
| Power Supply | -48V DC |
| Dimensions | Varies by configuration |
| Weight | Varies by configuration |
Provides document identification and a section listing.
Details the physical components and structure of the BMC system.
Describes key components like the central processor unit and PCA racks.
Explains the layout and designation of Printed Circuit Assemblies within BMC chassis.
Details the power supply units and their voltage outputs required for BMC operation.
System instructions for BMC operation, including boot program and resource allocation.
Higher-level software modules for data handling, reporting, and formatting.
Details the TEC/DSI PCAs which emulate MTU functions and handle data transfer.
Details how validated call records are stored in disk buffers and organized into files.
Describes the disk drives as an off-line data storage mechanism.
Covers the BMC disk system's support for data structures and file naming.
Covers organization and management of BMC resources, including site requirements and security.
Details access to and alteration of BMC hardware and operating parameters.
Explains the remote activity for retrieving call records, including link protection and site-specific information.
Describes the interface for communication between the BMC and the Host Office Collector.
Provides instructions for saving site-specific data to disk, ensuring its persistence.
Explains priority limiters for users and commands to control system access.
Categorizes BMC software commands into functional areas for operation and maintenance.
Commands used to control hard disk drive activity, primarily for installation and maintenance.
Commands related to BMC's ability to control access and prevent unauthorized system changes.
Commands used during installation and testing to tailor BMC to a specific site.
Commands providing low-level diagnostics to verify major BMC component operations.
Details information related to offloading data from the Switching System to the BMC.
Explains the transfer and organization of call record data.
Provides information on electrical and physical connections between the Switching System and BMC.
Details the TEC/DSI PCAs which emulate MTU functions and handle data transfer.
Details information specific to the installation of the TEC/DMS-10 interface.
Provides instructions for installing NT3T11 PCAs into interface boxes at the site.
Describes the connections provided on the rear panel of the NT3T11 Interface Box.
Steps for starting functional testing using BMC rocker switches and SETCLK command.
To Next Page
