4-44 Section 060-INDP-410 Command and Message Guide
297-6201-502 Standard 01.02 September 2000
where:
name- specifies the file name, up to six characters
ver- specifies file version. Range: 0 and 1-255 (0 is the latest version).
The system responds with a message in the same format as listed above in the
description of the LSTDIR ACT command. The valid values are different for
two of the items of the message. The value of ii (file ID) is always 00 and the
value of ss (file status) is 00, 02 (file closed, possibly open for read), or 11
(file open for write). Use the following command to display the directory
entries for a specified range of files.
>LSTDIR FILE name ver1 ver1(cr)
where:
ver1- specifies the beginning of the range of file versions. Range:
1-255
ver2- specifies the end of the range of file versions. Range: 1-255
(must be larger than ver1).
The system displays the disk directory data for the range of files specified in
the format described above.
Polling link adjustment commands
The polling link commands provide control of the port and activity of the
HOC polling link. The polling link commands are as follows:
• LINIT
• LNKDSC.
LINIT
LINIT is a maintenance command that initializes the AMA Teleprocessing
SCC and the associated software; causes the DTR on the active link to drop
momentarily, which disconnects the link. This command should be entered
immediately after the LNKDSC command.
Example of command usage
Issue the following command to initialize the polling links:
CAUTION
Use of these commands aborts a
polling session in progress.
To Next Page
Loading...
Need help?
General
