4-4 Section 060-INDP-410 Command and Message Guide
297-6201-502 Standard 01.02 September 2000
Table 4-2 lists and describes the alarm types. Table 4-3 lists and describes the
alarm level parameters.
Note: Any active alarm listed may be cleared using the RSERR
command. The RSERR command is described later in this subsection.
Table 4-1
ERRMAP subcommands
Subcommand Description
ERRMAP Displays a list of alarms, their current level assignments, and indicates
whether they are currently asserted for the active BMC processor.
ERRMAP event alarm
level
Changes the alarm type and/or alarm level for a specified device or
event number on the active BMC processor.
event = three digit number that specifies the device or event number.
Range: 1-99.
alarm = specifies the alarm type assigned to a particular device or
event number. The following alarm types are valid:
INHIBIT
MINOR
MAJOR
CRITICAL.
level = one digit number that indicates the seriousness of the fault.
Range: 0-3 (3 is the highest alarm level).
ERRMAP ALARMS Displays a list of alarms that have been asserted on both BMC
processors.
DOS S ERRMAP Displays a list of alarms, their current level assignments, and indicates
whether they are currently asserted for the standby BMC processor.
DOS S ERRMAP event
alarm level
Changes the alarm type and/or alarm level for a specified device or
event number on the standby BMC processor.
To Next Page
Loading...
Need help?
General
