Nortel DMS-10 - Program Version Commands; Site Dependent Data Commands

Maintenance Commands 9
BMC II BISYNC Quick Reference Guide
Program Version Commands
Site Dependent Data Commands
Command Name Explanation
ACTIVE PROCESSOR ONLY
VS Displays the active processor soft-
ware program version ID.
MON(cr)
VS
Displays the active processor’s
firmware program version ID.
Note: After using this command, type (CTRL)Z to get out of the
MON> overlay.
DSK VS Displays the disk firmware ver-
sion ID.
TECxCV Displays the active processor
firmware version ID for the
selected TEC/DSI PCA.
x - TEC/DSI Port ID: 1 or 2.
1 - TEC/DSI in slot A13.
2 - TEC/DSI in slot A12.
STANDBY PROCESSOR ONLY
Note: The following commands must be used while in the standby
(MON>) overlay. Enter the MONS command. Subsequent commands
are sent to the Standby Processor. Commands are once again directed to
the Active Processor when an illegal command or a (CNTRL)Z is
entered.
MONS Enters the standby (MON>) over-
lay.
VS Displays the standby processor
software program version ID.
MON>(cr)
VS
Displays the standby processor
firmware version ID.
TECxCV Displays the standby processor
firmware version ID for the
selected TEC/DSI PCA.
x - TEC/DSI Port ID: 1 or 2.
1 - TEC/DSI in slot A13.
2 - TEC/DSI in slot A12.
Note: After using any of these commands, type (CTRL)Z to get out of
the MON> overlay.
Command Name Explanation
BUFSZE Displays transmit frame size to data center
BUFSZxxx Sets transmit frame size to xxx (default 64
bytes/frame, 512 bytes max)*.
BVALDTE Examines the setting for the number of days
that a call record file is retained after it has
been polled. Default value is 15.