Notifier AFP-200 - Page 24

24 AFP-200 Instruction PN 15511:F2 10/11/99
Figure 2-7 Remote Printer Connections
Plug the DB-9 or DB-25
connector into the EIA-232 port
of the printer.
DB-25 Connections:
Connect TX (Pin 3) to TB4 terminal 1
Connect REF (Pin 7) to TB4 terminal 2
Connect RX (Pin 2) to TB4 terminal 3
Note: The EIA-232 printer interface may
also be used with EDP-listed equipment,
such as personal computers, to monitor the
control panel for supplementary purposes.
2.6 Remote Printers/CRT
The PRN-4 remote printer provides a hard-copy printout of
all status changes within the system and time-stamps the
printout with the current time and date. The PRN-4 provides
80 columns of data on standard nine-inch by eleven-inch
tractor-feed paper.
Installation
Remote printers require 120 VAC, 50/60 Hz primary power.
A secondary power source (battery backup) is not provided.
The use of a separate uninterruptable power supply (UPS),
UL-listed for Fire Protective Signaling is recommended.
Connection between the control panel and the PRN-4 is via
an EIA-232 interface. A custom cable must be assembled
for connection to the printer's EIA-232 port.
Printer Configuration
Refer to the documentation supplied with the PRN-4 for
instructions on the printer’s menu controls. Set the printer’s
options as listed in Figure 2-6.
NOITPONOITPO
NOITPO
NOITPONOITPOGNITTESGNITTES
GNITTES
GNITTESGNITTES
TSUJDAR/LTSUJDAR/L
TSUJDAR/L
TSUJDAR/LTSUJDAR/L
0
TNOFTNOF
TNOF
TNOFTNOF
TFARDSH
IPLIPL
IPL
IPLIPL
IPC6
CSECSE
CSE
CSECSE
RETCARAHC
CSE
LANOITCERIDIBLANOITCERIDIB
LANOITCERIDIB
LANOITCERIDIBLANOITCERIDIB
YPOC
NO
BAT-GCBAT-GC
BAT-GC
BAT-GCBAT-GC
CIHPARG
YRTNUOCYRTNUOC
YRTNUOC
YRTNUOCYRTNUOC
IICSAESU-E
RCOTUARCOTUA
RCOTUA
RCOTUARCOTUA
S1
NOITPOROLOCNOITPOROLOC
NOITPOROLOC
NOITPOROLOCNOITPOROLOC
DELLATSNITON
:NELMROF:NELMROF
:NELMROF
:NELMROF:NELMROF
SENIL
DRADNATS
06-PIL6
"5.01EVITUCEXE
IPCIPC
IPC
IPCIPC
IPC01
PIKSPIKS
PIKS
PIKSPIKS
"5.0
ETALUMEETALUME
ETALUME
ETALUMEETALUME
NOSPE
:O/I:O/I
:O/I
:O/I:O/I
DUAB
TAMROF
LACOTORP
k63
0042
POTS1,NEVE,TIB7
FFOX/NOX
RETCARAHCRETCARAHC
RETCARAHC
RETCARAHCRETCARAHC
TES
DRADNATSDRADNATS
DRADNATS
DRADNATSDRADNATS
OREZ.1SOREZ.1S
OREZ.1S
OREZ.1SOREZ.1SNONO
NO
NONO
FLOTUAFLOTUA
FLOTUA
FLOTUAFLOTUAFFOFFO
FFO
FFOFFO
KCOLNEMKCOLNEM
KCOLNEM
KCOLNEMKCOLNEMLLALLA
LLA
LLALLA
:REPAP:REPAP
:REPAP
:REPAP:REPAP
1NIB
2NIB
ELGNIS
ARTHSUP
ARTLLUP
LLORPAP
TROPAP
"27/21
"27/21
"27/21
"27/21
"27/21
"27/21
ON
Figure 2-6 PRN-4 Remote Printer Options
DB-9 Connections:
Connect TX (Pin 2) to TB4 terminal 1
Connect REF (Pin 5) to TB4 terminal 2
Connect RX (Pin 3) to TB4 terminal 3
Note: If also using a DB-9 connector for
upload/downlload connect a jumper
between pin 4 and pin 6.