Novatech Bitronics PowerPlex II - Environmental Specifications

24
ML0044B December 1, 2017 Copyright 2016 Bitronics, LLC
1.6 Environment
UL/CSA Listed, File Number E164178 (applies to standard chassis, does not
apply to extended chassis with I/O and serial port)
UL61010-1, Edition 3, Issue Date 2012/05/11
Safety Requirements for Electrical Equipment for Measurement, Control, and
Laboratory Use – Part 1: General Requirements
UL61010-2-30, Edition 1 – Issue Date 2012/05/11
Safety Requirements for Electrical Equipment for Measurement, Control, and
Laboratory Use – Part 2: Particular Requirements for Testing and Measuring Circuits
CSA C22.2 No. 61010-1-12-CAN/CSA, Edition 3, Issue Date 2012/05/01
CAN/CSA Safety Requirements for Electrical Equipment for Measurement, Control,
and Laboratory Use – Part 1: General Requirements
CSA C22.2 No. 61010-2-30-12-CAN/CSA, Edition 1 – Issue Date 2012/05/01
Safety Requirements for Electrical Equipment for Measurement, Control, and
Laboratory Use – Part 2-030: Particular Requirements for Testing and Measuring
Circuits
If applicable, the CE mark must be prominently marked on the case label.
European Community Directive on EMC (EMCD) 2014/30/EU,
superceding 2004/108/EC and Directive 91/263/EC [TTE/SES].
European Community Directive on Low Voltage (LVD) 2014/35/EU,
superceding 2006/95/EC.
The object of the declaration described above is in conformity with the relevant Union harmonisation
legislation: Directives 2004/108/EC & 2006/95/EC (until April 19th, 2016) and Directives 2014/30/EU
&, 2014/35/EU (from April 20th, 2016).
Product and Generic Standards
The following product and generic standards were used to establish conformity:
Low Voltage (Product Safety)
IEC/EN 61010-1, Edition 3, Issue Date 2010
Safety Requirements for Electrical Equipment for Measurement, Control, and
Laboratory Use – Part 1: General Requirements
IEC/EN 61010-2-30, Edition 1 – Issue Date 2010
Safety Requirements for Electrical Equipment for Measurement, Control, and
Laboratory Use – Part 2-030: Particular Requirements for Testing and Measuring
Circuits
EMC: EN 61326-1: 2013 (Supersedes EN 61326-1: 2006),
EN 61000-6-2: 2005 + AC: 2005,
EN 61000-6-4: 2007 + A1:2011 (IEC date 2010)