Battery Disconnect Switch
Use the MT 4100 Battery Disconnection Switch to remove battery power from the device (battery
models only). Move the switch toward the dot to place the battery in the ON position. Move the switch
away from the dot to place the battery in the OFF position. The following figure shows the MT 4100
Battery Disconnection Switch in the OFF position.
You must place the Battery Disconnection Switch in the ON position before using the optional backup
battery for programming or operating the MT 4100.
WARNING! If the Battery Disconnection Switch remains in the ON position with no external power
applied for an extended period of time, then the battery may significantly lose its charging capability.
WARNING! Before connecting to any auxiliary I/O device, you must apply power to the MT 4100 by
moving the Battery Power Switch to the ON position. Failure to apply power to the MT 4100 before
connecting auxiliary devices may result in damage to the attached I/O device.
NOTE: Move the Battery Disconnection Switch to the OFF position when transporting the device by
air.
MT 4100 User Guide 11
To Next Page
Loading...
