Test Preparation
Use the following instructions to configure the Novatel Wireless modem to communicate with the
Novatel Wireless test server using UDP.
Before you begin, consider the following points:
l
Most configurations are Mobile Originate only.
l
A mobile modem initiates a conversation with a remote server before it can talk to the modem.
l
IP addresses are dynamically assigned and can change.
l
Some IP addresses are NAT and are non-routable.
Use the following configuration commands and settings to address these points:
l
Modem ID/name = “My_MT_TEST”
l
Remote Server address = http://apitest.nvtl.com/UDPAPP/
l
Remote Server IP port = 1721
Ensure the device is powered up and connected to the computer. Use a tool like Hyperterminal or
similar to communicate with the device.
MT 4100 User Guide 27
To Next Page
Loading...
