MT 4100 User Guide 49
R&TTE
This device has been fully tested and complies with the requirements of EN301 489-1, EN301 489-3,
EN301 489-7, EN60950-1, IEC60950-1, EN62311, and EN300 440-2. Compliance to EN301 511 has
been demonstrated through testing performed on this device and the embedded wireless module. RF
exposure levels are below the recommended levels at distances of 6.7 cm between the antenna and
user.
Novatel Wireless hereby declares that this device is in compliance with the essential requirements and
other provisions of the Directive 1999/5/EC.
A full copy of the declaration of conformity can be found at http://documentation.nvtl.com.
Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the
device.
Cet appareil est conforme aux normes d’Industrie Canada exempts de license(s) RSS. Son
fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas provoquer
d’interférences, et (2) cet appareil doit accepter toute interférence, y compris les interférences pouvant
provoquer un fonctionnement indésirable de l’appareil.
ROHS COMPLIANCE
This device has been designed to comply with the European Union Restriction of the Use of Certain
Hazardous Substances in Electrical and Electronic Equipment (RoHS) Directive (2002/95/EC), effective
since July 1, 2006.
DISCLAIMER
The information and instructions contained within this publication comply with all FCC, GCF, PTCRB,
R&TTE, IMEI and other applicable codes that are in effect at the time of publication. Novatel Wireless
disclaims all responsibility for any act or omissions, or for breach of law, code or regulation, including
local or state codes, performed by a third party. Novatel Wireless strongly recommends that all
installations, hookups, transmissions, etc., be performed by persons who are experienced in the fields of
radio frequency technologies. Novatel Wireless acknowledges that the installation, setup and
transmission guidelines contained within this publication are guidelines, and that each installation may
have variables outside of the guidelines contained herein. Said variables must be taken into
consideration when installing or using the product, and Novatel Wireless shall not be responsible for
installations or transmissions that fall outside of the parameters set forth in this publication.
To Next Page
Loading...
