Novoferm DCC-80 - General Information; Contents and Target Group; Illustrations; Explanation of Symbols

1General information
1.1Contents and target group
These assembly and operating instructions describe the door drive DCC-80 for the
versions NHK, SK, ER, SK-WE, NHK-WE (hereinafter referred to as "DCC"). The in-
structions are intended for technicians that install and maintain the product, and for
the operator using the product.
1.2Illustrations
The illustrations in these assembly and operating instructions help you to better un-
derstand the descriptions and procedures. The illustrations only serve as examples
and may deviate slightly from your product's actual appearance.
1.3Explanation of symbols
1.3.1Pictograms and signal words
Important information in these assembly and operating instructions is marked with
the following pictograms.
DANGER
DANGER
... indicates a hazardous situation which, if not avoided, will result in death or
serious injury.
WARNING
WARNING
... indicates a hazardous situation which, if not avoided, could result in death or
serious injury.
CAUTION
CAUTION
... indicates a hazardous situation which, if not avoided, could result in minor or
moderate injury.
1.3.2Hazard symbols
⁠
Warning of electrical voltage!
This symbol indicates dangers to the life and health of persons due to
electrical voltage when handling the system.
⁠
Crush hazard to the whole body!
This sign indicates hazardous situations with a crush hazard to the
whole body.
⁠
Crush hazard to limbs
This sign indicates hazardous situations with a limb crush hazard.
1.3.3Further notice and information symbols
NOTICE
NOTICE
... indicates important information (e.g. material damage), but does not indicate
dangers.
⁠
Info!
Information marked with this symbol helps you to carry out your tasks
quickly and safely.
a
⁠
Refers to a graphic of the corresponding connection variant in the Fig-
ures chapter.
15/h
⁠
This symbol indicates that the door drive door drive is designed for a
cycle sequence of 15cycles per hour.
2Safety
Observe the following safety information:
WARNING
Risk of injury when disregarding the safety information and instructions!
Failure to observe the safety information and instructions can cause electric shock,
fire and/ or severe injuries.
n Following the safety information and directives given in these assembly and op-
erating instructions helps to avoid personal injuries and material damage while
working on and with the product.
n Before starting work on the product, read the assembly and operating instruc-
tions, especially the Safety chapter and the respective safety information, com-
pletely and carefully. It is important for you to have understood what you have
read.
n Keep all safety information and instructions for future reference.
n Only use genuine spare parts of the manufacturer. Wrong or faulty spare parts
can cause damage, malfunctions or even a total failure of the product.
n Children shall not play with the appliance.
n Cleaning and user maintenance shall not be made by children without supervi-
sion.
n Failure to comply with the safety information and directives given in these in-
structions or with the accident prevention regulations and general safety regula-
tions relevant to the field of application shall exempt the manufacturer or its
representative from all liability and shall render any damage claims null and
void.
2.1Intended use
The DCC is designed exclusively for opening and closing spring-balanced or weight-
balanced industrial sectional doors. It may not be used for garage doors without
spring-balancing or weight-balancing mechanisms. Never make any modifications or
changes to the product that have not been expressly approved by the manufacturer.
Novoferm|3