NOVUS AUTOMATION www.fieldlogger.net 30/104
ETHERNET INTERFACE CONFIGURATION - SMTP
The SMTP button opens the parameters related to sending e-mails. The FieldLogger allows, in situations of alarm or
event, e-mails to be sent to multiple receivers. On this screen, the parameters related to the access to the e-mail server
must be configured, such as its IP address or server name (in case you enabled the DNS – name being up to 50
characters), in addition to the user (maximum of 50 characters) and password (maximum of 12 characters).
Finally, you must configure the parameters of the e-mail to be sent in case of an alarm event. This e-mail has a subject
(maximum of 32 characters) and has a part of the message body that is user defined (up to 64 characters) and that is the
same for all alarms or events. The e-mail of the sender (maximum of 50 characters) and the e-mails of the receivers
(maximum of 50 characters for each one) must also be configured.
Ethernet Interface - SMTP Configuration
ETHERNET INTERFACE CONFIGURATION - E-MAIL RECEIVERS
For the insertion of the of e-mail receivers, you should click on the button "Edit List". A new window will open, allowing for
the inclusion and removal of e-mails from the receivers list. All potential receivers of alarm or event e-mails must be
included in this window. The decision of which alarms or events will be sent to which receivers will be made later, on
alarms configuration screen!
Ethernet Interface - Configuration of E-mail Receivers
To Next Page
Loading...
