Novus fieldlogger - Ethernet Interface Configuration

To Next Page

To Previous Page

NOVUS AUTOMATION www.fieldlogger.net 31/104

ETHERNET INTERFACE CONFIGURATION - SNMP

The SNMP protocol can be enabled and configured by clicking on the SNMP button. SNMP in the FieldLogger is read-

only. Thus, you should set up the community for access (maximum of 16 characters) and connection port.

For using traps, you must enable them separately. You should also set up the IP address and destination port for the

traps.

Ethernet Interface – SNMP Configuration

Novus fieldlogger - Ethernet Interface Configuration - Snmp