NV-DVR1104/CD, NV-DVR1108/CD and NV-DVR1116/CD ver. 1.1 - user's manual
All rights reserved © NOVUS Security Sp. z o.o.
19
in order to activate sequence mode on spot monitor SPOT SWITCHING position should be set
to ON.
When sequence mode is active, display time can be settled individually for each camera in seconds
( 1 to99). If camera is set to OFF image from this camera automatically will not be displayed in
sequence mode.
CAUTION: camera image, which is displayed in sequence mode on spot monitor, can be a bit
brightened on main monitor. Therefore it is recommended to turn off sequence mode when the spot
monitor is unused.
When motion detection and alarm inputs are active automatic sequence mode is aborted for the event
duration. in his time only alarm camera will be displayed. Displaying time depends on alarm settings.
If SPOT SWITCHING position is set to ON, the last selected or last alarm camera from main monitor
will be displayed on spot monitor (when motion detection or alarm inputs are active)
(6) TIME DISPLAY if this option is set to ON time/date information will be
displayed on the main screen;
(9) SYSTEM SELECT This option is used to select TV system standard. PAL or
NTSC system can be selected.
DEVICE MENU
▪ SPOT SWITCHING ON
▪ CAM01 02SEC ▪ CAM09 02SEC
▪ CAM02 02SEC ▪ CAM10 02SEC
▪ CAM03 02SEC ▪ CAM11 02SEC
▪ CAM04 02SEC ▪ CAM12 02SEC
▪ CAM05 02SEC ▪ CAM13 02SEC
▪ CAM06 02SEC ▪ CAM14 02SEC
▪ CAM07 02SEC ▪ CAM15 02SEC
▪ CAM08 02SEC ▪ CAM16 02SEC
▪ EXIT
SPOT SETUP
ENTER -SET
MENU EXIT
To Next Page
Loading...
