49
English
7 Mounting and Removing the Bur Guard
Applicable Attachment
Slim Handpiece 200
Super Slim Handpiece 200
_ Removing
1
Place the Wrench for Slim/Super Slim (P200-1ARA-W) Ⓐ onto the Removal Ring Ⓑ, loosen the Removal Ring Ⓑ by rotating it in the
direction of Ⓒ and pull the Bur Guard Ⓓ straight out.
Ⓒ
Ⓑ
Ⓓ
Ⓐ
_ Mounting
1
Align the Bur Guard Ⓓ and Attachment Ⓔ and tighten the
Removal Ring Ⓑ manually.
Ⓓ
Ⓔ
Ⓑ
2
Rotate the Removal Ring Ⓑ in the direction of Ⓕ with the
Wrench for Slim/Super Slim (P200-1ARA-W) Ⓐ to fix it firmly.
Ⓕ
Ⓑ
Ⓐ
8 Check before Operation
Conduct check before operation according to the following procedure to confirm that there are no abnormalities. If any abnormality is
observed, perform "11 Troubleshooting".
1
Attach the Attachment to the Motor, then attach the Cutting
Accessory to the attachment. Refer to Check before Operation
of each Attachment.
2
Check for abnormalities at the connection part of the
Attachment and Cutting Accessory.
3
Operate the Attachment at the rotational speed permissible for
the Cutting Accessory mounted. Confirm that nothing is loose
and that no abnormal vibration, heating or noise occurs.
If any abnormality is observed, stop use and perform "11
Troubleshooting".
4
Ensure that there are no abnormalities before use.
To Next Page
Loading...
Need help?
General
