NUM 1020 - 9 N;M Auto Function; 1000 M AUTO Function; General; Using the N;M AUTO Function

N/M AUTO Function
en-938872/2 9 - 1
9
9 N/M AUTO Function
9.1 General 9 - 3
9.1.1 General Requirements for N/M AUTO 9 - 3
9.1.2 Uninterpolated Axes and NMA Axis 9 - 3
9.1.3 Errors in N/M AUTO 9 - 4
9.1.4 Processing Example 9 - 4
9.1.5 Examples of Programmes and Use 9 - 5
9.2 Using the N/M AUTO Function 9 - 7
9.3 Procedure After Enabling the N/M AUTO Function 9 - 8
9.3.1 Using the Jogs 9 - 8
9.3.1.1 Case of Axis Clamping While E912xx Is Set 9 - 8
9.3.2 Using the Handwheel 9 - 9
9.3.2.1 Axis Assignment 9 - 9
9.3.2.2 Example of Use with Handwheel 9 - 9
9.3.2.3 Movements with the Handwheel 9 - 9
9.3.2.4 Case of Axis Clamping While E912xx Is Set 9 - 10
9.4 Stopping and Restarting in N/M AUTO Mode 9 - 11
9.5 Checks Included in N/M AUTO 9 - 12
9.5.1 Acceleration Checks 9 - 12
9.5.2 Speed Checks 9 - 12
9.5.3 Check of Travels 9 - 12
9.5.4 Miscellaneous Checks 9 - 12