NUM 1020 - Appendix B Table of Symbolic Variable Management Commands B

Table of Symbolic Variable Management Commands
en-938872/2 B - 1
B
Appendix B Table of Symbolic Variable Management
Commands
BUILD: Creation of a table for storing the paths of a profile (see 4.2.1)
General syntax:
BUILD [TAB(G / X / Y / I / J,NB)] H.. N.. +n N..+n
BCLR: Inhibiting of programming of M functions and/or one or more axes. Resets the bits
of [
•
IBE0(i)] and [
•
IBE1(i)] (see 4.2.5)
Syntax:
BCLR [
•
BMxx] / [
•
IBX(i)] / [
•
IBE0(i)] / [
•
IBE1(i)]
BSET: Enabling of programming of M functions and/or one or more axes. Sets the bits
of [
•
IBE0(i)] and [
•
IBE1(i)] (see 4.2.5)
Syntax:
BSET [
•
BMxx] / [
•
IBX(i)] / [
•
IBE0(i)] / [
•
IBE1(i)]
CUT: Elimination of grooves or parts of grooves located within the tool relief angle
(see 4.2.4)
Syntax:
CUT
*
[Pa(7,Nb)] / Angle
MOVE: Copy of all of part of a table into another table (see 4.2.8)
General syntax:
MOVE [Pj(nj,mj)],mj1,mj2 = [Pi(ni,mi)],mi1,mi2 / j1=i1 / j2=i2 /jn=in
P.BUILD: Creation of a table for storing the dimensions of the interpolation plane of a profile
(see 4.2.2)
General syntax:
P.BUILD [TAB(7,NB)] H.. N.. +n N..+n