4 en-938872/2
8 RTCP Function 8 - 1
8.1 General 8 - 3
8.2 Using the RTCP Function 8 - 4
8.3 Description of Movements 8 - 6
8.4 Processing Related to the RTCP Function 8 - 9
8.5 Use in JOG and INTERV Modes 8 - 11
8.6 Restrictions and Conditions of Use 8 - 11
9 N/M AUTO Function 9 - 1
9.1 General 9 - 3
9.2 Using the N/M AUTO Function 9 - 7
9.3 Procedure After Enabling the N/M AUTO
Function 9 - 8
9.4 Stopping and Restarting in N/M AUTO Mode 9 - 11
9.5 Checks Included in N/M AUTO 9 - 12
Appendix A Table of Structured Programming Commands A - 1
Appendix B Table of Symbolic Variable Management Commands B - 1
Appendix C Table of Programme Status Access Symbols C - 1
C.1 Addressing G and M Functions C - 3
C.2 Addressing a List of Bits C - 3
C.3 Addressing a Value C - 3
C.4 Addressing a List of Values C - 4
Appendix D Table of Symbols Stored in Variables L900 to L951 D - 1
D.1 Symbols Stored in Variables L900 to L925 D - 3
D.2 Symbols Stored in Variables L926 to L951 D - 3
To Next Page
Loading...
