5 - 16 en-938872/2
(test spindle rotation if axis is programmed)
IF [I]<>0 THEN [E]=[M3/4]
*
[.RS] G79 [E]=0 N81
ENDI
G79 N800
(error message)
N81 E.831 (spindle stopped)
N82 E.882 (hole bottom not programmed)
N83 E.890 (tool orientation incompatible)
N84 E.894 (ER prohibited in G20)
N85 E.895 (G21, G22 prohibited during this cycle)
(—movements—)
N11 X[dimension]
N12 Y[dimension]
N13 Z[dimension]
N14 U[dimension]
N15 V[dimension]
N16 W[dimension]
N800
To Next Page
Loading...
