36
Breakaway Floor-tool
The oor-tool design incorporates a breakaway feature.
Allowing it to safely disengage from its mounting should it become caught on an obstruction, during forward machine
movement. (See Fig.34)
To re-attach the blade to its holder. First loosen the retaining knobs on the oor-tool body and slide onto the holding bracket.
Tighten retaining knobs to nger tight. (See Fig.35)
Machine Usage Advice
To operate, turn the main control on / off key to position ‘1’ (ON), select
water-ow rate, chemical mix (see page 32), lower the oor-tool
(see page 30) and select forward (see page 20), press the start / stop
trigger.
Vacuum pick-up, water-ow and chemical-dose will turn on automatically
and the machine will move forward.
Adjust the speed to suit the conditions using the variable speed control
(see page 20).
The clean-water / chemical mix is dispersed evenly via the ‘THRU- FEED’
scrubbing brushes.
The waste-water is then retrieved by the suction oor-tool.
Overlap each scrubbing path by 10 cm to ensure an even clean.
Do not operate the machine on inclines that exceed (9%), when full.
If streaking occurs wipe oor-tool blades clean (see Fig.36).
On heavily soiled oors use a ‘double scrub’ technique.
First pre-scrub the oor with the oor-tool in the raised position, allow
the chemical time to work then scrub the area a second time with the
oor-tool lowered.
Machine Operation
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.
! !
Note: Care must be taken to reduce speed when
cornering or when manoeuvring around obstacles
To Next Page
Loading...
